I'm not sure I've ever used AUTO for the speed with Writelog with any radio.
Right now I have:
K3/100 on COM1 38,400, poll checked and PTT = YES
K2/100 on COM2 (USB), 4800, poll checked and PTT = YES
Winkeyer2 on COM3 (USB)
And, since I installed 10.68 it has been working fine.
73 Hank K8DD
----- Original Message -----
From: "Bruce Meier" <bemeier@bellsouth.net>
To: "'WriteLog'" <Writelog@contesting.com>
Sent: Friday, November 21, 2008 10:42 AM
Subject: [WriteLog] K3 question with v10.68
>I have been using version 10.67 since I first put my (2) K3s on the air
> using the K2 as the RIG in SETUP - PORTs. Just this morning, as there
> are
> no contests this weekend that I will be participating in, I upgraded to
> v10.68 that has the K3 listed in SETUP - PORTS. To my surprise it did not
> work. NO RIG was displayed for both K3s. (I have Writelog setup for (2)
> rigs with a DXDoubler for SO2R.) After a few failed attempts at
> resolution I decided to manually set the baud selection to 4800. They
> now
> work !!!
>
> Question: Why does AUTO BAUD work fine in 10.67 and not in 10.68?
>
> Is anyone else having this problem?
>
> 73,
> Bruce - N1LN
> (aka: NC4KW)
>
> K3# 1062
> K3# 1193
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|