Dan
I wrot the section [RIGS] on my writelog ini file , some one have a sample
of how must be ?
Maybe is where i need to take a good look and fill it correctly, have the
idea that there is clue
tks for all the support
jus to inform the IC-7000 is mainly my 6m 2m and UHF rig , CW is used with
the internal memories most of the time and some times the direct key or the
LPT port hard keying.
J. Hector Garcia XE2K / WT6J
Mexicali B.C DM22fp
P.O.Box 73
El Centro CA 92244-0073
USA
http://www.xe2k.net
http://www.dxxe.org
--- On Wed, 7/8/09, Joe Subich, W4TV <lists@subich.com> wrote:
From: Joe Subich, W4TV <lists@subich.com>
Subject: RE: [WriteLog] IC-7000 DTR /RTS PTT still not working right
To: "'Dan Karg'" <dkarg@ekarg.com>, writelog@contesting.com
Cc: j_hector_garcia@sbcglobal.net
Date: Wednesday, July 8, 2009, 6:53 PM
Hector,
Dan is correct ... I missed the fact that the XGGCOMMS interface
used serial port power from the DTR line. Use Dan's suggested
additions to the [RIGS] section of WRITELOG.INI (simply add the
[RIGS] heading/section if it does not already exist).
> That was the only combination I could find that would get
> close to what you need. Again you will not have PTT available
> for voice keying.
Since you are using an IC-7000 which supports PTT switching via
the CI-V interface, you can use it for PTT. Simply, set "Comm
PTT" for your radio port to "YES." I’m not a fan of software
PTT but in this case because of interface limitations it is
your only choice.
73,
... Joe, W4TV
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Dan Karg
> Sent: Wednesday, July 08, 2009 6:15 PM
> To: writelog@contesting.com
> Subject: Re: [WriteLog] IC-7000 DTR /RTS PTT still not working right
>
>
> Hector,
> I did some testing of this as it peaked my interest. I did
> not find a complete solution. Part of the problem is that
> your interface (and many others) rely on getting DTR high to
> power the interface. I was able to get WL into that state,
> but all the CW and PTT functions are unusable (no CW anyways
> on your interface), and there would be no PTT for Voice Keying.
>
> If you turn off all the CW check box's (ie don't point CW to
> a port) in WL and add the following 2 lines to the [RIGS]
> section of writlog.ini
>
> COM12_DTR_INIT=1
> COM12_RTS_INIT=0
>
> You will have to change COM12 to what ever port you are using
> for your radio interface.
>
> This will raise DTR (to power the interface) and drop RTS (so no PTT)
>
> That was the only combination I could find that would get
> close to what you need. Again you will not have PTT available
> for voice keying.
>
>
>
> Dan K0TI
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Hector
> Garcia XE2K
> Sent: Wednesday, July 08, 2009 12:33 AM
> To: writelog@contesting.com; lists@subich.com
> Subject: Re: [WriteLog] IC-7000 DTR /RTS PTT still not working right
>
> Joe
>
> Made that and several other things and the same results I
> think that my problem is this
>
> Add settings to [RIGS] for initializing RTS/DTR for Rig COM ports
>
> but i'm Lost where is or how to make the correct SET UP
>
> i add the [RIGS] section and nothing happen
>
> I can send my writelog INI if that help
>
> J. Hector Garcia XE2K / WT6J
>
> Mexicali B.C DM22fp
>
> P.O.Box 73
>
> El Centro CA 92244-0073
>
> USA
>
> http://www.xe2k.net
>
> http://www.dxxe.org
>
> --- On Mon, 7/6/09, Joe Subich, W4TV <lists@subich.com> wrote:
>
> From: Joe Subich, W4TV <lists@subich.com>
> Subject: Re: [WriteLog] IC-7000 DTR /RTS PTT
> To: "'Hector Garcia XE2K'" <j_hector_garcia@sbcglobal.net>,
> writelog@contesting.com
> Date: Monday, July 6, 2009, 8:13 PM
>
>
> Hector,
>
> Even though you do not use the interface for CW (and have no
> "key" line connected) set WriteLog as follows:
>
> In Set-up | Ports
>
> 1) check "CW" on the same port as you use for the radio
> 2) Set CW Keyer type to "PC Generates"
> 3) check "All mode PTT on CW Port RTS"
> 4) click "OK"
>
> When you return to the main screen, select "Setup -> Save
> Configuration.
>
> This will put PTT on the same port as CI-V and should release
> the constant PTT when WriteLog is running.
>
> 73,
>
> ... Joe, W4TV
>
>
>
>
> > -----Original Message-----
> > From: writelog-bounces@contesting.com
> > [mailto:writelog-bounces@contesting.com] On Behalf Of Hector Garcia
> > XE2K
> > Sent: Monday, July 06, 2009 9:59 PM
> > To: writelog@contesting.com; lists@subich.com
> > Subject: Re: [WriteLog] IC-7000 DTR /RTS PTT
> >
> >
> > My interface is very simple
> >
> > G8XGG is the builder
> >
> > here the web page http://www.xggcomms.com/page9.htm
> >
> > and this is the one i have
> >
> > http://cgi.ebay.com/Icom-PSK31-CAT-Interface-IC-703-706-78-718
> > -and-more_W0QQitemZ370167897186QQcmdZViewItemQQptZLH_DefaultDo
> > main_0?hash=item562fb9dc62&_trksid=p3286.c0.m14&_trkparms=65%3
> > A12|66%3A2|39%3A1|72%3A1234|293%3A1|294%3A50
> >
> >
> >
> > J. Hector Garcia XE2K / WT6J
> >
> > Mexicali B.C DM22fp
> >
> > P.O.Box 73
> >
> > El Centro CA 92244-0073
> >
> > USA
> >
> > http://www.xe2k.net
> >
> > http://www.dxxe.org
> >
> > --- On Mon, 7/6/09, Joe Subich, W4TV <lists@subich.com> wrote:
> >
> > From: Joe Subich, W4TV <lists@subich.com>
> > Subject: RE: [WriteLog] IC-7000 DTR /RTS PTT
> > To: "'Hector Garcia XE2K'" <j_hector_garcia@sbcglobal.net>,
> > writelog@contesting.com
> > Date: Monday, July 6, 2009, 5:39 PM
> >
> >
> > Without knowing the specifications on your particular
> interface it is
> > difficult to provide specific advice for your hardware. However,
> > unless you are doing CW and PTT on the radio port or the radio
> > requires handshake on RTS/CTS (e.g., Kenwood), WriteLog
> sets RTS and
> > DTR high on the radio ports.
> >
> > See the "WRITELOG.INI [RIGS] section of the help file for the
> > information on overriding the default operation of RTS and DTR.
> >
> > 73,
> >
> > ... Joe, W4TV
> >
> >
> >
> >
> > > -----Original Message-----
> > > From: writelog-bounces@contesting.com
> > > [mailto:writelog-bounces@contesting.com] On Behalf Of
> Hector Garcia
> > > XE2K
> > > Sent: Monday, July 06, 2009 4:55 PM
> > > To: writelog@contesting.com
> > > Subject: [WriteLog] IC-7000 DTR /RTS PTT
> > >
> > >
> > > Hi Guys
> > >
> > > Having several Days trying to find the correct
> configuration to make
> > > work the IC-7000 with WL and stop the PTT to be stuck when start
> > > the WL
> > >
> > > I have an CI-V sound card interface that i bought on Ebay from a
> > > Seller of UK, the interface works WITH NO ISSUES with the
> Ham Radio
> > > Delux, just select the DTR and the radio works no problem, this
> > > interface is a Serial with DB-9 connector and can be
> used with the
> > > USB to Serial adaptor and no problem.
> > >
> > > I try to change all the things I THINK was needed based on the
> > > HELP files for ICOM in WL and some info i get from the List, but
> > > changes make no difference the CI-V works fine at any baud speed
> > > but when connecting the 13 pins DIN the PTT get stuck , removing
> > > the radio from the PORT set up on WL the PTT stop. i'm
> just using
> > > the CI_V and will like to have all working
> > >
> > > Wha is my problem or what i'm missing to change on the
> WRITELOG.INI
> > > to make the radio stop the PTT when selected.
> > >
> > >
> > >
> > > J. Hector Garcia XE2K / WT6J
> > >
> > > Mexicali B.C DM22fp
> > >
> > > P.O.Box 73
> > >
> > > El Centro CA 92244-0073
> > >
> > > USA
> > >
> > > http://www.xe2k.net
> > >
> > > http://www.dxxe.org
> _______________________________________________
> > > WriteLog mailing list
> > > WriteLog@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/writelog
> > > WriteLog on the web: http://www.writelog.com/
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|