Allthough cranking the voltage past 13.8 volts probably won't damage anything,
there is no guarantee to that, so just keep that n mind.
Aslo, for something like server supply, this could well be a Class A digital
device, with significantly higher noise.
________________________________
From: RFI <[email protected]> on behalf of Brian Moran
via RFI <[email protected]>
Sent: Friday, June 5, 2020 11:58 AM
To: [email protected] <[email protected]>; Jim Brown
<[email protected]>
Subject: Re: [RFI] Report on 12V 750W server supplies
I recently purchased the DPS-750RB A model, which is also shown as a
HSTNS-PD18. Using the instructions on YouTube, I easily changed the voltage to
13.9v. I haven't had time to look for RFI using an SDR, and certainly won't
have as extensive a test setup as Gary does.
I did not try to adjust higher than 14v, though that might be a good
experiment. If I had any confidence I wouldn't damage something by doing so,
I'd be willing to try higher voltages :-)
-Brian N9ADG
On Thursday, June 4, 2020, 10:41:17 PM PDT, Jim Brown
<[email protected]> wrote:
On 6/4/2020 2:49 PM, Gary Johnson wrote:
> Output is fixed right at 12V but there are notes on the web about how to
> change an internal feedback resistor to tweak that up a bit.
Thanks Gary. Do you know how high V+ can be set? Some radios, notably
Elecraft rigs, have lower IMD at higher supply voltages, with 15V max.
73, Jim K9YC
_______________________________________________
RFI mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/rfi
|