Hi All,
I have f/s a loaded Ten Tec Omni VI Option 3 upgrade to a
Omni VI Plus. Just back from Ten Tec in June of this year, repaired and
fully checked out. The crystal oven was bad and replaced with the 2 ppm
TCXO. Meter op amp driver replaced along with the meter. A few other
minor issues were also repaired. Total cost for repair, $391.
I will include all documentation from Ten Tec.
Purchased from the original (sight impaired) owner. Includes
the following: Stock Filters, plus #282 250 Hz CW Filter, #285 500 Hz
CW Filter, #288 1.8 Khz SSB Filter, #219 500 Hz RTTY Filter, 2 ppm TCXO,
Model 257 Voice Annunciator Board, Model 259 ALC Annunciator Board that
lets you set Mic gain by ear. All options were factory installed as was
option 3. I don't have the manual, but it is available as a free
download on the Ten Tec website.
Also included is T-T desk mic. No DC power cord, as I'm using
that on my FLEX 5000. Cosmetically, an easy 9+ and in perfect working
condition. Shipped double boxed. Shipping weight comes in about 30 lb
and box dimensions are 24 x 25 x 13. I can send pictures to interested
parties.
Asking $1025 or best reasonable offer plus shipping.
I also have available a Ten Tec 961 matching power supply with
speaker. $95 plus shipping (It's HEAVY).
Tnx & 73 de Bob,
N2OAM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|