The shorting link between TXEN and TXOUT is only needed if TxLoop is
enabled in the menus. If TxLoop is enabled and no shorting link, then
the radio will be prevented from transmitting any power.
That power output level sounds like the final transistors are bad.
Alc should light up in CW mode. For SSB mode, mic modulation is needed
for ALC to light up.
Carl Moreschi N4PY
127 River Moss Way
Hertford, NC 27944
www.n4py.com
On 2/17/2023 8:15 AM, ROLAND HOWELL via TenTec wrote:
Hi folks
The Jupiter arrived and onto the workbench.
Testing so far has yielded the following results:-
RF output on all modes is 2.5watts at 3amps current use.
On frequency.
When i try to TX the ALC lights up, not all modes.
RX appears to be ok, it is hearing the tone from my 2022e at -110dBm.
Should there be a shorting link between TX TXena, somewhere in my grey
cell i recall that a link should be fitted, but, perhaps not this radio.
Nice looking t/rx, may be a keeper, to add to my 2 x paragons,
omni6+,argosy 2 x 2 and omni 'd'.
As always advice and suggestions greatly appreciated
73
Snowy G0HZE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|