Further investigation on the PA devices fitted to the Jupiter, Q3/Q4 not
sd1405 but MRF454S, drivers Q1/Q2 again not 2sc3133 but RD16HHFso the PA
has been got at by previous owner, this is troubling somewhat.
FL2/FL3 have a white fur on the external surface, probably the same
inside which is not good, have replacements on the way.
i have found a length of mini co-ax unsoldered at 1 end, it goes from
term 19 on the power supply/ancillary board fitted to the back panel to
PCB U7 but that end is disconnected, looking at the pins it seems to fit
on RX-OUT, thats the 1 that has extra solder on it.
Thanks to Bob K4 for clarifying the output devices for me.
Snowy G0HZE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|