Seems there was some concern by one of the posters about cable capacitance
effect on the motor pulses. I believe that water has a very high dielectric
constant (around 80?). Could it be possible that water in the conduit causes
shunt capacitance high enough to be a problem? Just a thought FWIW. 73,
Dan, N5AR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Bill Carnett
Sent: Tuesday, June 12, 2007 6:05 PM
To: towertalk@contesting.com
Cc: k3bz@arrl.net
Subject: [TowerTalk] SteppIR problem-update from the front lines
Aloha to all,
Just got back from trying the splice at the base of
the tower....works fine.
As I was preparing the splice I noted how robust the
insulation seems, i.e. doubt there could be any damage
to the cable inside of the conduit. But also, how
small the twisted pairs were...22 ga, however, I did
learn that there are a number of 4 L and MonstIR yagis
out there with control lines of > 500 feet. I did
note a posting referencing a "heavier" cable for the
longer runs, maybe I got the smaller cable??
Anyhow, so far so good. We'll see how the new 500
foot cable works, though I'm a bit reluctant to put it
back into the conduit....perhaps there are evil humors
down there? Hi Hi.
Will keep the group posted. Thanks to all for the
robust and very informative dialog...great learning
experience for sure.
73, Bill
AH6FC/7
____________________________________________________________________________
________
Need Mail bonding?
Go to the Yahoo! Mail Q&A for great tips from Yahoo! Answers users.
http://answers.yahoo.com/dir/?link=list&sid=396546091
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|