Hi, Richard.
If you're talking about a rotor plate for inside the tower, K0XG Systems
sells them for 65G: http://www.k0xg.com/products/product15.html
-Larry Wi5A
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Richard L. King
Sent: Monday, October 15, 2007 9:09 PM
To: [email protected]
Subject: [TowerTalk] Using Rohn 65G
I am thinking about using some Rohn 65G for a short self-supporting tower to
hold some VHF/UHF yagi antennas.
I understand that accessory plates for rotators and thrust bearings are not
available from Rohn for this size tower.
I wonder what others have done about this? Do you have to fabricate your own
accessory plates or is there someone, somewhere where this hardware can be
purchased?
73, Richard - K5NA
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|