I have a friend that has recently had a rohn 25 tower fall in a severe
thunderstorm bending and breaking the section at the bottom. The tower
is in concrete. Is there a best way to mate a section back to what is
existing? Is is best to put a sleeve around each leg of the tower and
through bolt it? Is it best to sleeve and weld it? Is it best to cut the
existing section off at the ground and use a rohn base plate? Or are
there better suggestions? Thanks you, Joe N4JBK
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|