| To: | <[email protected]> |
|---|---|
| Subject: | [TowerTalk] How To Cut "Slits" In Aluminum Tubing? |
| From: | "Marshall Stewart KA5M" <[email protected]> |
| Date: | Sun, 8 Jun 2008 17:10:56 -0500 |
| List-post: | <[email protected]">mailto:[email protected]> |
What is the best way to cut "slits" in the end of an aluminum tubing antenna element to allow it to be compressed enough with a hose clamp to fit tightly on the next smaller size tubing telescoped inside? Marsh Stewart, KA5M _______________________________________________ _______________________________________________ TowerTalk mailing list [email protected] http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TowerTalk] Notes on the K5LAD Tailtwister repair web page, Scott Robbins |
|---|---|
| Next by Date: | Re: [TowerTalk] How To Cut "Slits" In Aluminum Tubing?, Randy |
| Previous by Thread: | Re: [TowerTalk] Positioning A LM-70 Crank-Up, Roger (K8RI) |
| Next by Thread: | Re: [TowerTalk] How To Cut "Slits" In Aluminum Tubing?, Randy |
| Indexes: | [Date] [Thread] [Top] [All Lists] |