| To: | <towertalk@contesting.com> |
|---|---|
| Subject: | [TowerTalk] Equalizer Plates |
| From: | "Drax Felton" <draxfelton@gmail.com> |
| Date: | Tue, 25 Nov 2008 23:52:54 -0500 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
The instructions with my Rohn equalizer plates say to "Stake All Nuts After Assembly." What does that mean? I know to run some wire through the turnbuckles, but this is about the nuts holding the turnbuckles to the equalizer plates. How do I stake a nut? -KB3X _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Was "43ft Vertical Feeding, jimlux |
|---|---|
| Next by Date: | Re: [TowerTalk] Equalizer Plates, Dino Darling |
| Previous by Thread: | Re: [TowerTalk] TowerTalk Digest, Vol 71, Issue 87, Doug Grant |
| Next by Thread: | Re: [TowerTalk] Equalizer Plates, Dino Darling |
| Indexes: | [Date] [Thread] [Top] [All Lists] |