> Have you actually seen the AIM produce SWR values less than 1:1,
> or are you critical of it simply because the scale has values
> below 1?
No, I do not have one ... I am critical of an incorrect display
as shown in that data. As I said, either the designer does not
understand enough to produce a product that displays (operates)
correctly or the user's ability to configure the measuring device
is questionable. In either case, the measurements (results)
must be questioned.
73,
... Joe, W4TV
On 5/22/2010 10:16 AM, Steve Hunt wrote:
> Joe,
>
> Have you actually seen the AIM produce SWR values less than 1:1, or are
> you critical of it simply because the scale has values below 1?
>
> If the latter, you'll be pleased to know that values below 1 on the SWR
> scale were removed a couple of versions of software ago.
>
> 73,
> Steve G3TXQ
>
> Joe Subich, W4TV wrote:
>> > On which equipment/software/DUT does one see SWR<1?
>>
>> AIM 2170 - for example:
>> http://www.balundesigns.com/catalog/1-1%205kw%20Scan.jpg
>>
>> Note the SWR scale on the left vertical axis ... all the
>> way down to 0:1.
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
