Towertalk
[Top] [All Lists]

Re: [TowerTalk] Divining rods and pyramids

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Divining rods and pyramids
From: David Gilbert <xdavid@cis-broadband.com>
Date: Wed, 01 Sep 2010 12:32:34 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Either that is the most hilariously sarcastic post I have seen in quite 
a while (if so, kudos to you), or it is now apparent that I have been 
mysteriously transported to some weird alternative universe .... 
possibly Narnia or some place similar to it.   Anyone out there know how 
I can find the door in the back of the closet to get back home?

Dave   AB7E


On 9/1/2010 9:15 AM, David J. Sourdis - HK1A wrote:
> I did two "L"  out of an old coat hanger wire. About 6" for the handles and 
> 30" for long part of the wire L.
> Take one on each hand as  an inverted L , being the vertical part of the 
> inverted L, the 6" handles, the long parts of the Ls should be horizontal, 
> parallel and looking in the same direction you are walking on. When there is 
> an underground discontinuity made of water the Ls will tend to rotate to the 
> center, making the 30 inch sides cross each other. Even if you rotate your 
> wrists to the outside (right wrist going clockwise, opposite for left), 
> making the rods to move upwards on an inclined plane, the rods will rotate to 
> the center overcoming the pull of gravity for small inclinations. I could 
> locate the positions of the corners of an old sewer system well in my 
> backyard with this rods. Not a good place to put a tower, hihi
> More interestingly: I did the rods from a book about Pyramids ("The magical 
> powers of the pyramid" is the translation of the spanish title). Using thin 
> cardboard, I made a scaled version of the Gizah pyramids, about three inches 
> high and a second one about three times that size.
> When the rods where moved at belly height over one of the pyramids sitting on 
> the floor, the rods would rotate to the center very quick, ONLY IF the faces 
> of the pyramid were aligned with the cardinal points the rods would move, if 
> the faces were aligned with NE, SE, NW and SW, instead of N, S, E, W, the 
> rods wouldn't move.
> To make the pyramid: Draw a circle on the cardboard. The radius of the circle 
> multiplied by 1,0517 (the radius + 5.17%) is the square base's side lenght. 
> With the base lenght draw four end to end chords on the circle and then draw 
> lines between the ends of the chords and the circle center, this lines will 
> be the edges of the pyramid that part from the square base corners and meet 
> at the top (circle center). The chords are the four bottom sides of the 
> faces. The four resulting triangles are the faces of your pyramid, no base 
> needed. Then cut out the drawing and bend by the edges to form the pyramid, 
> it is wise to leave an extra flip strip on one of the end faces to make the 
> closing and gluing of the pyramid easier and stronger.
> CHORD:http://en.wikipedia.org/wiki/Secant_line
> Sorry about Pyramid talk, back to Tower Talk :o)
> 73
>
>
> David
> HK1A
> EC5KXA
> ex-HK1KXA
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>