Towertalk
[Top] [All Lists]

Re: [TowerTalk] Yaesu Rotator Refurbish?

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Yaesu Rotator Refurbish?
From: Adam Shirley WJ4X <wj4x@amsat.org>
Date: Sun, 10 Apr 2011 16:59:05 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
If it's still working, just take it apart and regrease the ring bearing.
I used synthetic wheel bearing grease.

Don't loose the balls, and it's pretty straight forward.


On 4/10/2011 10:02 AM, Michael Warren wrote:
> I been a ham for more than 25 years; and I am approachIng retirement with 
> time to return to CW enjoyment. 
>  I recently purchased a 80 ft freestanding tower with a Yaesu G-2800SDX 
> Rotator which is still atop the tower and fully functional for the last 10 
> years. 
>  My question is what should I expect in terms of preparation and 
> refurbishment of this particular Yaesu Rotator prior to re-erecting the tower.
> Any thoughts, comments, or personal experiences to share?
> 
> Tnx cul 73
> 
> Michael Warren
> ka5rej
> Ravenna, Texas
> ka5rej@yahoo.com
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>