Towertalk
[Top] [All Lists]

Re: [TowerTalk] TowerTalk Digest, Vol 100, Issue 27, Sealed container ne

To: "K8RI on TT" <k8ri-on-towertalk@tm.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] TowerTalk Digest, Vol 100, Issue 27, Sealed container needed for tuner
From: "Jim W7RY" <w7ry@inbox.com>
Reply-to: Jim W7RY <w7ry@inbox.com>
Date: Thu, 14 Apr 2011 20:56:51 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Drill and thread?  Why not just drill and install the fitting with a lock 
nut? What am I missing here?
73
Jim W7RY



--------------------------------------------------
From: "K8RI on TT" <k8ri-on-towertalk@tm.net>
Sent: Thursday, April 14, 2011 8:22 PM
To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] TowerTalk Digest, Vol 100, Issue 27, Sealed 
container needed for tuner

> On 4/14/2011 8:00 PM, Terry G. Glagowski wrote:
>> The TUPPERWARE containers lasted about 2 years at my QTH, then they got 
>> brittle
>> and cracked apart... but for $9 was a good try!
>> The grey plastic electrical boxes available at Lowes / Home Depot for 
>> about $25
>> might be a good bet...
>> They come with a rubber seal around the edges of a lid that screws on 
>> tight...
>> BUT... you need to put an opening for the cables... suggest you simply 
>> cut a
>> hole in the BOTTOM...
>
> Drill a hole and thread it (NPT) for fit the cable connectors made for
> the job. They come in different sizes that will fit most any cable
> including Rg8, 58m CAT5, LMR 400 and 600, rotator cable, ... etc.
> I use them for all cables not fitted to bulkhead connectors at the tower
> box.
>
>> Perhaps glue a PVC pipe section into the hole if you want more than 
>> that...
>> Tightly sealed containers can lead to pressure differences with 
>> temperature and
>> barometric changes, and a hole lets the water from condensation OUT!
>
> The 3 and 4" conduit I use lets it breathe easily.
>
> 73
>
> Roger (K8RI)
>
>> Last summer, I replaced all the TUPPERWARE boxes that surrounded junction 
>> points
>> at the base of towers, and installed these boxes around coax switches 
>> that were
>> out in the weather for 5 years...  If the tuner fits in it OK, you will 
>> probably
>> have a good choice there...
>>
>> Terry / W1TR
>>
>>
>> -----Original Message-----
>> From: towertalk-request@contesting.com 
>> [mailto:towertalk-request@contesting.com]
>>
>> Sent: Wednesday, April 13, 2011 9:18 PM
>> To: towertalk@contesting.com
>> Subject: TowerTalk Digest, Vol 100, Issue 27
>>
>> Message: 4
>> Date: Wed, 13 Apr 2011 19:17:14 -0500
>> From: chas<chasm@texas.net>
>> Subject: [TowerTalk] Sealed container needed for tuner
>> To: towertalk<towertalk@contesting.com>
>> Message-ID:<4DA63D0A.4050805@texas.net>
>> Content-Type: text/plain; charset=ISO-8859-1
>>
>> I want to mount an SGC-239 tuner on the tower below a vertical.  but I 
>> need a UV
>> proof, sealed, water tight container that I can put the tuner inside - 
>> and then
>> put that tuner in a tupperware? into another container if it can be
>> found.   And all of this as cheap as possible.
>>
>> I think that NMEA cases are just too expensive but that might have to be 
>> the end
>> choice.
>>
>> thanks
>> chas k5dam
>>
>> **
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1321 / Virus Database: 1500/3574 - Release Date: 04/14/11
> 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>