[TowerTalk] Replacing K1550 with K2550 on TRX80 raising fixture

[Tony <dxdx@optonline.net>]

All,

I called Fulton and asked if the bolt pattern on their K2550 winch was 
the same as the K1550. The tech said it was close, but not a match. I 
know that more than one member of this reflector has replaced the 1550 
with the 2550 on a  U.S. Tower TX80 raising fixture without modifying 
the mounting plates on either the winch or the fixture so the only thing 
I can think of is that Fulton may have modified the bolt slots on the 
winch at one time. Any ideas?

Tony
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk