As much as I hate to admit it, at times I have been guilty of leaving rotor
cables or even coax outside unprotected from the rain and snow. Later on,
wanting to put it to some use and after stripping off some insulation, I
find that the surface of the copper conductors have been tarnished with a
nice black coating. The tarnish makes it impossible to solder to even with
an acid core flux. Other than physical abrasion, does anyone have any
tricks or solution/chemical that will remove that tarnish?
Gedas, W8BYA
Gallery at http://w8bya.com
Light travels faster than sound....
This is why some people appear bright until you hear them speak.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|