Towertalk
[Top] [All Lists]

Re: [TowerTalk] PL259 Connectors Part 2

To: Hans Hammarquist via TowerTalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] PL259 Connectors Part 2
From: <ww3s@zoominternet.net>
Date: Wed, 11 May 2016 02:07:40 +0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Its on Tims webpage, k3lr.com






Sent from my Windows tablet





From: Jim Brown
Sent: ‎Tuesday‎, ‎May‎ ‎10‎, ‎2016 ‎8‎:‎05‎ ‎PM
To: Hans Hammarquist via TowerTalk





On Tue,5/10/2016 4:48 PM, Kevin Stover wrote:
> I tried to pull one off a waste piece of coax. Connector clamped in my 
> bench vise and two guys pulling on the coax.
> Didn't budge. Try that with the soldered connector. 

A properly installed soldered Amphenol 83-1SP makes a pretty strong 
connection to the coax. "Properly installed" includes stripping just 
enough braid so that it shows through the solder holes and so that the 
coax jacket screws into the connector shell, soldering the braid at each 
hole so that it flows well, and doing a good soldering job on the center 
conductor. Many times, I've had to yank pretty hard on the RG11 attached 
to high dipoles to guide them away from tree limbs, etc. So far, I've 
never had one pull apart.

K3LR has developed a method of soldering the braid to the OUTSIDE of the 
connector shell and covering it with heat shrink. That's probably even 
stronger!  I've done that with a few connectors, but wasn't thrilled 
with the result. QST published it a few years ago, and I think it's 
somewhere on the internet.

73, Jim K9YC
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>