| To: | TowerTalk@contesting.com |
|---|---|
| Subject: | [TowerTalk] Swinging Gate rotor mounts. |
| From: | Dan Atchison via TowerTalk <towertalk@contesting.com> |
| Reply-to: | Dan Atchison <N3ND@aol.com> |
| Date: | Mon, 14 May 2018 09:43:02 -0400 |
| List-post: | <mailto:towertalk@contesting.com> |
Who manufactures "swinging gate" rotor mounts? W9IIX used to and I
remember there was a K4 who did, but I cannot locate any source through
my less than stellar google searches.
Dan -- N3ND _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Laying out radials around a stone fence, jimlux |
|---|---|
| Next by Date: | Re: [TowerTalk] Laying out radials around a stone fence, Les Kalmus |
| Previous by Thread: | [TowerTalk] Poly rod, Fiber glass rod, Fiber Protrusion rod tension?, CEPitts |
| Next by Thread: | Re: [TowerTalk] Swinging Gate rotor mounts., Bill Cotter |
| Indexes: | [Date] [Thread] [Top] [All Lists] |