If you are smart you have a floor flange and short piece of 1 1/4 inch pipe
fastened to the bottom of the bucket (or hog pan) for reassembly purposes.
Jim Rhodes
K0XU
On Mon, Dec 3, 2018, 13:20 Steve Bookout <[email protected] wrote:
> Hello all,
>
> Hint to those who have never taken one of these rotators apart.
>
> After you remove the bolts/screws holding the upper housing to the lower
> housing, place the rotator in a plastic 5 gallon bucket BEFORE YOU
> ACTUALLY SEPARATE THE TWO HOUSINGS. The ball bearings have a nasty
> habit of pouring out and running all over the room. You will spend
> plenty of time on your knees looking for all of them. This keeps them
> together in one place.
>
> Also, if the balls themselves are any bit questionable regarding their
> condition, you can purchase new ones from McMaster-Carr reasonably.
>
> www.mcmaster.com
>
> 73 de Steve, NR4M
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|