Amen!
Get Outlook for Android<https://aka.ms/ghei36>
________________________________
From: TowerTalk <towertalk-bounces@contesting.com> on behalf of k7lxc--- via
TowerTalk <towertalk@contesting.com>
Sent: Tuesday, December 4, 2018 12:58:29 PM
To: towertalk@contesting.com; w7zrc@yahoo.com
Subject: Re: [TowerTalk] Ham Antenna Rotator: The Teardown
> Years ago I remember reading to not use grease on the ball bearings as it
> just attracts dust and dirt. And, that the design from the factory did not
> call for grease. Is this correct or should one use a grease on the ball
> bearings?
I think you're confusing the rotator ball bearings with the ball bearings
in the Rohn thrust bearings. Grease the rotator. Do not grease the thrust
bearing.
CheersSteve K7LXCTOWER TECH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|