Hi Stan,
Tnx for the feedback. For now I will leave well enough alone. The dummy load
gets just a little warm. Seems like a sloping dipole for 60M on each side of
the tower would be worthwhile. But I shunt feed the tower on 160M. Concerned
about affecting my 160M signal.
73,
N2TK, Tony
From: Stan Stockton <[email protected]>
Sent: Thursday, January 24, 2019 2:02 PM
To: N2TK, Tony <[email protected]>
Cc: Towertalk <[email protected]>
Subject: Re: [TowerTalk] 80M 4-sq on 60M
You either warm up a dummy load or warm up components in the Comtek box. You
also won't have a good SWR.
A better alternative would be to put up another antenna that is resonant on 60m
and dump the dump power into that antenna so it can be radiated.
Stan, K5GO
On Thu, Jan 24, 2019, 12:54 PM N2TK, Tony <[email protected]
<mailto:[email protected]> wrote:
I have a wire 80M 4-sq with elevated radials using a Comtek box. It works
well and has a nice pattern. I also use it on 60M with a good SWR and some
F/B. 100W in gives me 35W dumped power. What would happen if I remove the
dumped power dummy load on 60M? Do I hurt anything? Do I reduce signal or
potentially cause a problem with the Comtek box? Max power is 100W.
Tnx for any feedback.
N2TK, Tony
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected] <mailto:[email protected]>
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|