Hello John
This might be helpful:
https://www.dxengineering.com/parts/dxe-mastlock
73
Tim K3LR
-----Original Message-----
From: TowerTalk [mailto:[email protected]] On Behalf Of John
Sloop
Sent: Thursday, December 26, 2019 5:02 PM
To: [email protected]
Subject: [TowerTalk] Lift Mast to Replace Rotator
I'm looking for suggestions to lift mast, with antennas just enough to
replace the rotator, which is a Ham III. Rotator is shelf mounted about 2
feet below the top thrust bearing. All ideas are appreciated.
John S.
AA0ES
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|