[Amps] Hello Everyone
Dennis Peterson
dennisissure at comporium.net
Sun Apr 25 11:00:10 PDT 2010
I'm new to this list and would like to find out some information regarding my TL-922 Amplifier.
This is an excellent amp but it seems to have a mind of its own. Whenever operating, after switching the Linear Switch from CW to SSB or SSB to CW the amplifier makes a popping or snapping type sound to which it sounds and appears as though it is coming from the mode switch.
PLEASE be advised that the amp is in standby mode when this happens and there is NO HOT SWITCHING whatsoever.
This scenario takes out either R6 and or R7 or both.
It has done this two times now. I have since replaced R6 with a 1 ohm 5 watt resistor and R7 with a 1/2 watt 1.5K ohm resistor. R7 had a 3/16" long crack in the body of the resistor and R6 was open. The Plate Current Meter needle is resting at 600 mA and thumping the bazel of the meters doesn't allow it to return to ZERO.
Has anyone had this problem with their 922? If so, what can be done to fix, rure or resolve this from re-occuring?
I'm not sure if there is a zero adjustment screw for the meter as it doesn't show unless I have to remove the front case cover or panel. The scenario has occured two times now.
Please provide me with the necessary information and diagrams or parts to resolve this. Thanking you in advance
K4CKDennis
Read my story below by clicking the URL:
http://www.yananow.net/Mentors/DennisD.htm
http://www.k4ckd.com
Dennis G. Peterson
326 East Jefferson Street
Apt 2
York, SC 29745
803-389-9366
More information about the Amps
mailing list