[Amps] Pulser

[Gary Schafer]

Your amp is always out of tune when operating SSB. It is only at maximum
efficiency at full power tune up. 

73
Gary  k4FMX

> -----Original Message-----
> From: Amps [mailto:amps-bounces at contesting.com] On Behalf Of Roger
> (K8RI)
> Sent: Monday, September 10, 2012 10:08 PM
> To: amps at contesting.com
> Subject: Re: [Amps] Pulser
> 
> On 9/10/2012 8:00 PM, Bill, W6WRT wrote:
> > I really don't understand why anyone feels the need to use a pulser
> for tuneup.
> >
> > If your amp can't do full power for the few seconds needed for a
> tuneup, you're
> > pushing it too hard anyway, IMO.
> 
> It's not whether the amp can do a full power tune up, it's now much it
> drags the HV down. Many of today's amps just don't have the HV
> regulation to keep it up under a full load so the amp will be out of
> tune for the higher SSB peaks, or even high speed CW at full power
> unless the EI ratio remains the same.
> 
> 73
> 
> Roger (K8RI)
> >
> > 73, Bill W6WRT
> > _______________________________________________
> > Amps mailing list
> > Amps at contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >
> 
> 
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps