[Amps] Non metallic paint for plywood ?
Tom Hellem
tom.hellem at gmail.com
Tue Oct 22 22:00:11 EDT 2019
Jim-
How about using a piece of 1/4" or so thick piece of plastic on top of the plywood under the choke? Then you wouldn't have to worry about the paint.
Tom H
K0SN
> On Oct 22, 2019, at 1:41 PM, Jim Thomson <jim.thom at telus.net> wrote:
>
> I'm going to stack 2 x identical sheets of 3/4" plywood together in the new 24" rack.
>
> The 127 lb Dahl 4H choke will sit dead center on the plywood. Is run of the mill
>
> paint in a spray bomb conductive ? Or should I be using indoor latex, outdoor latex... or something else, like BBQ repair high temp paint ? Or perhaps fire resistant paint ?
>
>
>
>
> 2x2 angle aluminum down each side of rack, with plywood on top of em. Entire mess will be up off the bottom just enough so I can get my hands underneath to tighten up the 1/4-20 nuts. 1/4-20 is max size that will fit the 4 x slotted holes in the 2 x angle steel's, at base of choke.
>
>
>
>
> I don't trust the insulation breakdown..... which is just a single sheet of....'fishtape' at bottom of each side of choke. Fishtape partially torn on one side. Each sheet is 21 x 22.75
>
>
>
>
> Only the top sheet and front and rear edges to be painted. Its just for aesthetics. The choke is part of a C-L-C experiment I am playing with these days..for a B+ supply. Choke has a 25 kv-65 A spst-nc kilovac ceramic relay across it.... plus an adjustable spark gap. Spark gap is just a pair of 1/4-20 silver plated brass screws..with 1/4-20 acorn nuts facing each other.
>
>
>
>
> Jim VE7RF
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
More information about the Amps
mailing list