[ct-user] CT 9.90.007 and Paddle
David Robbins K1TTT
k1ttt at arrl.net
Thu Jun 26 21:20:26 EDT 2003
Check that you aren't getting rf into the port... turn off or reduce
radio power. Doublecheck wiring and pin numbers, make sure no pins are
shorted and that pullup resistors are properly connected. Slow the
speed way down and try to send single dits and dahs to see if maybe you
have bounce in a paddle contact. Has it worked with earlier versions on
that machine or is this your first attempt??
David Robbins K1TTT
e-mail: mailto:k1ttt at arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: ct-user-bounces at contesting.com [mailto:ct-user-
> bounces at contesting.com] On Behalf Of Bob Schreibmaier
> Sent: Thursday, June 26, 2003 20:00
> To: ct-user at contesting.com
> Subject: [ct-user] CT 9.90.007 and Paddle
>
> I tried to use CT 9.90.007 and an external paddle on
> a Toshiba 486/50 laptop (QRP Field Day computer)
> running MS-DOS 6.22. I used the REVPADDLE command
> to get the left paddle to send dits and the right
> to send dahs.
>
> Sending with the motion necessary to send a "V",
> the first letter out is a "V", but the next one is an
> "F", followed by something unintelligible.
>
> I've tried not using REVPADDLE, but simply changing
> the paddle around. Same results.
>
> Has anyone else seen this behavior? Is it possible
> to fix?
>
> TIA.
>
> 73,
> ____ / _____ /
> / ) / / /
> /____/ ____ /___ (____ ____ /___ /___
> / ) / ) / ) ) / / ) /
> /_____/ /____/ /____/ _____/ (____ / / / . . .
>
> +---------------------------------------------------+
> | Bob Schreibmaier K3PH | E-mail: k3ph at ptd.net |
> | Kresgeville, PA 18333 | http://home.ptd.net/~k3ph |
> +---------------------------------------------------+
>
> _______________________________________________
> CT-User mailing list
> CT-User at contesting.com
> http://lists.contesting.com/mailman/listinfo/ct-user
More information about the CT-User
mailing list