[NA-User] NA 10.53 and Packet

Dan Zeitlin k2ywe@yahoo.com
Mon, 10 Dec 2001 05:47:59 -0800 (PST)

I have the same setup, but I find that entering the
packet window in NA (and CT) and typing [CTRL]-C puts
me into the modem's command mode.  No feedback from
the modem appears on the screen, though.  Typing
[CTRL]-C [space] and then the command you wish to
execute should work.  I sometimes use the "Converse"
command this way if I have exited NA (or CT) and then
started it back up again without signing off the
packet cluster.  Once in a while this procedure fails,
and the I end up back at the DOS command prompt (after
all, [CRTL]-C is a DOS kill command).
Dan Z
--- Ray C Fallen <nd8l@juno.com> wrote:
> Hi...
> Thanks for reading this.  I'm using 10.53 and an
> MFJ-1278 Packet Modem.
> In order to initialize the modem in command mode
> while using 10.53, I
> have to
> power off the modem and turn it back on again to get
> the CMD: prompt. 
> Pressing control and C doesn't seem to work.
> This can be a pain as I get disconnected on busy
> weeekends.
> The packet works fine (the control and C works)
> using DXBase for DOS 5.0.
> Any ideas?
> Ray
> Youngstown, Ohio
> _______________________________________________
> NA-User mailing list
> NA-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user


Dan Zeitlin
Annapolis, Maryland

Do You Yahoo!?
Send your FREE holiday greetings online!