[NA-User] CQP file issue

David Pruett k8cc at comcast.net
Sat Oct 7 23:47:34 EDT 2006


I'm afraid I don't have an explanation for you.  When I test log a MARP 
QSO here, it works fine, both with 10.59 and the recent 10.61, and also 
with both the old and new CALCTY.MLT files.  (The abbreviation for 
Mariposa County - MARP - is the same in both the old and new files.)


Rob Neece wrote:
> I have been inactive for a while and just decided to get on the CQP 
> and warm up my CW.  I copied the data at the end of the post by David 
> Pruett and made two files: CALCTY.MLT and CALCTY.ALI.  I'm outside 
> CA, so the CALCTY.MLT file is the one I think I need, and it contains 
> lines like the following:
> Alameda:                ALAM: CTY:  6;
> I corrected the ALPI problem, put the file in the proper place, and 
> then fired up NA1059.  Everything was OK until I made a QSO and tried 
> to log MARP.  NA indicated the county was not a valid QTH.  Alt-L 
> shows the expected list of 4-letter counties including MARP, so I am 
> at a loss.  Where did I go wrong?
> Rob
> _______________________________________________
> NA-User mailing list
> NA-User at contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user
> NA on the web:  http://www.datomonline.com/

More information about the NA-User mailing list