[RTTY] Questions

[Bill, W6WRT]

ORIGINAL MESSAGE:

On Thu, 17 Jun 2010 11:33:42 -0500, "Tom Martin"
<tmartin at chartermi.net> wrote:

>
>1.  To operate 75 baud do you just check it in MMTY.?  No other changes in the program setup?

REPLY:

If you are running MMTTY in standalone mode, go to Options>SetupMMTTY,
click the Decode tab and change the baud rate, then click OK. After
doing this DO NOT click the "Ham" button on the main window or it will
revert back to 45 baud. 

If you are using it with N1MM Logger there is another step. Go to the
Digital window, click Setup>settings and uncheck the vox that says
(MMTTY) Send ham default on run to S&P change. Leaving it checked will
do the same as with standalone above - it will revert back to 45 baud
when you go to S&P mode. Also, an unfortunate side effect of having
this box unchecked is it will not reset your tones to the ham default
when going to S&P. To overcome this, also uncheck the box directly
below the one mentioned above and be sure on the main window, the Mark
box is set to 2125 Hz, and leave AFC off for the duration of the
contest. A little complicated, but you only have to do it once.

73, Bill W6WRT