[SCCC] Running an Elecraft K3/0-Mini Via USB Cable

[Ron Fitch (WQ6X)]

On 4/11/2025 8:44 PM, Ron Fitch (WQ6X) wrote:
> On 4/11/2025 6:04 PM, Paul Kube wrote:
>> Unplug the K3/0-MiniUSB cable from your personal computer if it is
>> presently connected.
>>  Download the Driver setup file from FTDI website
>> (http://www.ftdichip.com/Drivers/VCP.htm).
>>  Run the driver setup wizard and wait for the setup process to
>> complete.
>>  Reboot your personal computer.
>>  Plug in the USB cable to your personal computer and K3/0-Mini.
>>  Using the Device Manager, verify the com port drivers installed
>> properly.
>
> I DiD that and it created USB Serial Port (COM7) & USB Serial Port (COM8).
>
> N1MM sees the ports (set at 38400 8N1) for both ports,
> but does not respond to them.
>
I tried responding to Paul's K6PO at outlook.com address
and it gets rejected, so I am posting here.

    Ron
   WQ6X