[TenTec] Re: Zero beating with the OMNI-6+

[k8do]

Match the tones.... Holding in the CW button causes it to inject a tone into
the audio chain that matches the offset you have selected...  When you
adjust the tuning dial so that the incoming audio note matches the CW-button
tone, you are zero beat with his carrier frequency...

Denny
----- Original Message -----
From: "Roy Koeppe" <royanjoy@ncn.net>
To: "Ten Tec Reflector" <tentec@contesting.com>
Sent: Monday, November 27, 2000 3:03 PM
Subject: [TenTec] Re: Zero beating with the OMNI-6+


>
> Asked,
>
>
> "Hey, guys, i'm re-reading my Omni 6+ manual.  This rig does a lot!  I
> still can't seem to figure out the CW zero beat procedure.  I know i
> need
> to hold in the CW button while tuning in the CW station.  But do i match
> the tone of that station or do i zero out the tone to get on his exact
> freq??"
>
>    Bob Mauro, Mauro@Idt.Net        Amateur Radio Station KZ2G
>
>
>  Bob,
>
> As with all modern transceivers, you simply match the tone of the
> received station to that of your side tone.
>
> 73,      Roy        K6XK           Iowa    Outback
>
>
>
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
>



--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com