[TenTec] 240 160M Transverter

[Edward Crawford]

I am not sure about the 160 converter, but when I was using the 242 VFO, the accessory jumper plug stayed in the drawer as it was not needed for use of the VFO, because the jumpers were installed in the plug from the VFO.
Might be worth trying without it.
73 and good luck. ed/w4wvw
  ----- Original Message ----- 
  From: David N.<mailto:pkmaint at yahoo.com> 
  To: tentec at contesting.com<mailto:tentec at contesting.com> 
  Sent: Saturday, December 27, 2003 8:26 PM
  Subject: [TenTec] 240 160M Transverter


  Does anyone out there now how to hook up the transverter to the 540 triton??
  I have the big plug put into the accesory jack and have to the shorting plug and placed
  it in the accesory jack on the transverter. what about the transverter out and the recv ant?
  Also what switches need to be were on the 540?
  So far  with it presently hooked up and the transverter turned to 1.8 I get nothing I have tried to resonate from the 540 but nothing. so apparently the transverter is not working. what else do I need to do? I don't have a manual on either of the units
  Thanks 
  David KR4OW


  ---------------------------------
  Do you Yahoo!?
  Yahoo! Photos - Get your photo on the big screen in Times Square
  _______________________________________________
  TenTec mailing list
  TenTec at contesting.com<mailto:TenTec at contesting.com>
  http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>