[TenTec] Firmware upgrade: click in headphone and Keyer timing

[Robert Carroll]

I notice the click in the right headphone pad when using panoramic mode on
the main receiver.  I don't hear it with main selected for both earpads.

Bob W2WG

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of DK2GZ at aol.com
Sent: Friday, December 03, 2004 12:28 PM
To: tentec at contesting.com
Subject: [TenTec] Firmware upgrade: click in headphone and Keyer timing

Hello TT-Group
 
I just installed the 1.372 firmware.
 
Two things i noticed in difference to 1.371:
 
1. Click in headphone
Using headphones and listen only the main RX, there is a click in right  
headphone pad.
If I mute the main RX and listen only to the Sub-RX there is no click  
present.
 
2. Keyer timing
I also see no difference in Mode A and B.
Also still cant use the internal keyer because of the timing, stick still  
with the external IDOM-Press-Keyer
 
No solution also with the new firmware:
 
Preamp or ATT not stored per band. If you using the preamp on the  highbands
and going back to the low bands you have to switch the preamp off  manual.
Even my K2 and TS570 can this remember per band!
 
If you are set the PBT +-  for RTTY operation and switch back to CW  you
have 
clear
the PBT setting manual.
 
73 de Harry, DK2GZ
 
 
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec