[TenTec] [Fwd: [ct-user] CT DOS with Ten-Tec Omni VI]

[Ed]

Ken Brown wrote:
> Hi Ed,
> 
> Thanks for the suggestion. I am only using pins 2, 3 & 5 for the RS-232 
> to the computer. I am also using the appropriate pins for the 301 remote 
> knob. No other pins on the Omni VI 25 pin D connector are being used for 
> anything.


Guess you are using the Y cable to use both control and the 301. I use 
the "sport" jack for rig control and have no problems. I think you might 
find that the "Y" cable may be the problem. In the back part of the 
manual is a schematic of the onboard 232 pinouts. What pins do the 301 
use.? There is also a programming guideline in the manual. Have you 
tried unplugging the 301 and see what happens.? Try eliminating the "Y" 
cable also. Just some off-the-wall suggestions. I'll look thru my manual 
in the morning.

Ed W3NR