[TenTec] Com 1 speed?

[J. Reed]

Thank you Carl... Jim Reed
  ----- Original Message ----- 
  From: Carl Moreschi 
  To: Discussion of Ten-Tec Equipment 
  Sent: Tuesday, June 07, 2005 07:57
  Subject: Re: [TenTec] Com 1 speed?


  My N4PY program sets the comport speed to 57600 baud.  This is the only
  speed the Pegasus runs at and the program would not work unless this was the
  set speed.  When you look at system information for comports, you are only
  seeing the default settings if the program had not actually set them.

  73,

  Carl Moreschi N4PY
  Franklinton, NC
  ----- Original Message ----- 
  From: "J. Reed" <jhreed at chilitech.net>
  To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
  Sent: Tuesday, June 07, 2005 6:23 AM
  Subject: Re: [TenTec] Com 1 speed?


  > N4PY Pegasus, TenTec 550 /computer program:
  >
  > Dell Dimension 3000 @ 2.4ghz, 512mb ram, etc.
  >
  > Ran 'system' information while  'Peg 550' was on.
  >
  > Feeling like the com-1 speed is too low, (9600 baud,
  > 8 bits, 1 stop). Can I boot the port speed up to 57,600
  > or is it 'set' by the your program?   Thanks,  Jim Reed.
  >
  >
  > _______________________________________________
  > TenTec mailing list
  > TenTec at contesting.com
  > http://lists.contesting.com/mailman/listinfo/tentec

  _______________________________________________
  TenTec mailing list
  TenTec at contesting.com
  http://lists.contesting.com/mailman/listinfo/tentec