[TenTec] Ham Radio Deluxe

[Dell Ray]

Hi Dyke
  I don't remember If you have a manual, And if you checked the settings according to the manual. When I ran TRX the first time The only thing i had to do was select the rig then pick my baud rate and comm port. Everthing else I left as default.  I have Addr.=04,  Ctrl=E0,  mem=90,  Stop bits=2,  TRX Port1=Com 4,  CAT speed=19200,   dual control=checked, RTS Enable=checked,  DTR enabled=checked,  PTT=CAT,  TX Interrupt=DSR,.
  I use a over the counter Belkin cable from computer to rig. I am using vista 64 on a duel Intel CPU. I also had to buy a serial card but mine was a Rosewell. Just be sure the rig is the same settings as Comp.
  Also you might try a master rest of the Rig. Might have a brain cramp.
  

Dell R Smith
Prosser,Wa 
KI7XD DN-06
OMNI VI Opt1


--- On Mon, 1/26/09, DW Holtman <tubestuff at comcast.net> wrote:

> From: DW Holtman <tubestuff at comcast.net>
> Subject: Re: [TenTec] Ham Radio Deluxe
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Date: Monday, January 26, 2009, 6:40 PM
> Hello,
> 
> I installed a PCI serial card from byterunner. Windows
> under XT under 
> Hardware information, tells me that it is properly
> installed and working. I 
> triple checked the wiring in the cable. Tried Hyperterminal
> as suggested in 
> the Ten Tec troubleshooting document. Not too sure that I
> had Hyperterminal 
> was set up correctly? Still no luck, no communication. I
> tried two software 
> packages, HRD and TRX.
> 
> Any suggestions on where I should go from here?
> 
> Thank you,
> DW Holtman
> WB7SSN
> 
> ----- Original Message ----- 
> From: "Mike, K9UW" <k9uw at wi-net.com>
> To: "Discussion of Ten-Tec Equipment"
> <tentec at contesting.com>
> Sent: Sunday, January 18, 2009 6:05 PM
> Subject: Re: [TenTec] Ham Radio Deluxe
> 
> 
> > DW, I've used PCI serial cards from Byterunner on
> several occasions with
> > excellent results.  They're cheaper than most
> places as well.  Their
> > telephone rep told me, last time I called, that Hams
> were regular 
> > customers.
> >
> >
> <http://www.byterunner.com/byterunner/category=2+Serial+(RS-232)+PCI-bus+cards/exact_match=exact>
> >
> >
> > 73, de Mike, K9UW
> > Amherst, WI
> >
> > DW Holtman wrote:
> >> Tim,
> >>
> >> I will check tomorrow and see if  I can find a
> Serial Port PCI  Card. Is
> >> there any drivers etc required, or is a Serial
> Card plug and go.
> >>
> >> Thank you again,
> >> DW Holtman
> >> WB7SSN
> >>
> >>
> >>
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec