[TenTec] When loading Orion 565 V2.064x11

John T. Fleming john at w3gqj.net
Thu Feb 17 14:51:27 PST 2011


John,

I am confused which is easy when you get old! :-} Don't you do a master
reset in step 5 and then you say to do it again? Thanks.
73,
John

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Henry, John
Sent: Thursday, February 17, 2011 4:13 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] When loading Orion 565 V2.064x11

When updating to V2.064x11, it is recommended that after you upgrade
the firmware, that you turn the rig off, and perform a RAM Clear reset
followed by a master reset and clear user memories and filter
settings.

RAM clear is as follows:
1. Orion off, power supply on.
2. Press and hold the LCK button just below the VFO B knob.
3.Turn on Orion and continue to hold the LCK button until Master Reset is
displayed on the screen. BATTERY FAILURE may also be displayed, disregard.
4. Release the LCK button and allow the Orion to boot to 14.250.
5. Turn the Orion Off and perform the Master Reset using The MAIN RX/TX
button. User memories and filter settings MUST be cleared.

THEN perform a Master Reset.

John Henry
TenTec Engineering
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




More information about the TenTec mailing list