[TenTec] 238A-C roller inductor
Wade Staggs
tvman1954 at gmail.com
Wed Jun 19 06:59:18 EDT 2013
I must agree with Bob/K4TAX ... My MFJ-989C Tuner is not built anywhere
close to the quality of your Tuner. I bought it new in 1995 and by never
tuning under high power, the only issue with it was from being not used for
a couple of years. When it came out of Moth Balls and returned to service.
After a good going over and cleaning with DeOxit, all is well. I also
checked all mechanical pieces for dried lubricants and used a light oil
where needed. Most Roller Inductors don't Wear Out .... they just get Dirty
Contacts and such.
73 from Wade/KJ4WS
On Tue, Jun 18, 2013 at 3:27 PM, denton sprague <denton at oregontrail.net>wrote:
> Got a nice used(again)238A TT tuner and the roller inductor is getting a
> tad long in the tooth…
> Priced a new one out of TT but can't justify it right now.
> Has anyone installed an aftermarket inductor in their TT tuner…if so, can
> you send me the details. Thanks...
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list