[TenTec] Dim LEDs on Orion front panel

[Rick - DJ0IP / NJ0IP]

I have not had this problem, but I'll bet $5 on the connector conductivity.
73
Rick, DJ0IP

-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Barry N1EU
Sent: Thursday, October 03, 2013 5:49 PM
To: Orion565; Discussion of Ten-Tec Equipment
Subject: [TenTec] Dim LEDs on Orion front panel

The LEDs illuminating the ANT and VFO switch matrix are VERY dim,
essentially impossible to see.  Before I tear into my Orion 565, I was
wondering if anybody else has previously troubleshot this exact issue.

I suspect either impaired connector conductivity or a bad cap.  But has
anybody already done this deed and can report their findings?

Thanks & 73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec