[TenTec] Anyone using LP-PAN with Orion/RX366?
Barry N1EU
barry.n1eu at gmail.com
Thu Feb 13 12:39:19 EST 2014
I just ordered the parts from N8LP to reconfigure my original style
LP-PAN to 9MHz with preamp and I will connect it to the 9MHz output of
the RX366. I will hopefully report back in a week or two.
73, Barry N1EU
On Thu, Feb 13, 2014 at 5:34 PM, Floyd Sense <floyd at k8ac.net> wrote:
> Barry - do you know if the output level of the RX366 if different from what
> you get when using the IF tap point on the main receiver? I've been using
> LP-Pan/NaP3 fed from a tap on the main receiver through the Clifton Labs
> buffer amp. I set the gain on that buffer to either 3 or 6 dB when I built
> it and that's proven to be a good level. I have the newer LP-Pan with the
> preamp, but I run with it off as the additional gain just isn't needed. If
> I had built the buffer with zero dB gain, the preamp may have been useful.
>
> 73, Floyd - K8AC
>
>
> On 2/13/2014 12:00 PM, tentec-request at contesting.com wrote:
>>
>> From: Barry N1EU<barry.n1eu at gmail.com>
>> To: Discussion of Ten-Tec Equipment<tentec at contesting.com>, Orion565
>> <orion565 at yahoogroups.com>
>> Subject: [TenTec] Anyone using LP-PAN with Orion/RX366?
>> Message-ID:
>>
>> <CAFmfzDtxjo_uZrDSGxKe35sULpjn4GZBtMzB4UaK7jZHQpaNZA at mail.gmail.com>
>> Content-Type: text/plain; charset=UTF-8
>>
>> Is anyone out there successfully using LP-PAN pan adapter with the
>> 9MHz output of the RX366 subreceiver? Are you using a buffer amp on
>> the if output or using the optional add-on LP-PAN preamp (as suggested
>> by John Henry)? Any other comments/tips appreciated.
>>
>> Thanks & 73,
>> Barry N1EU
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
More information about the TenTec
mailing list