[TenTec] Anyone using LP-PAN with Orion/RX366?

[John Huffman]

Floyd -

I have the Orion connected to LP-Pan via the 9MHz IF in the main 
receiver.  It works acceptably but has odd dips in the display around 
the selected frequency.  They vary depending on the roofing filter 
selected.  Most folks aren't bothered by this and the dips are 
eliminated if you have the hardware noise blanker on.  But, I wanted 
better, like I have with my K3 and LP-Pan.

I bought the RX-366 and used it with my LP-Pan with these results:
- no dips, but a hump in the display near the selected frequency.
- a significant spike on the display about 11 kHz below the selected 
frequency.
- the RX frequency is that of the sub receiver so you have to have the 
sub-receiver track the main receiver for point and click QSY. N4PY 
software can handle that for you.

Nothing is perfect.  In the end I could tolerate the shortcomings of the 
9MHz main receiver IF better than the RX-366 issues and returned the RX-366.

You may feel differently.

73 de K1ESE
John


On 2/13/2014 12:34 PM, Floyd Sense wrote:
> Barry - do you know if the output level of the RX366 if different from 
> what you get when using the IF tap point on the main receiver? I've 
> been using LP-Pan/NaP3 fed from a tap on the main receiver through the 
> Clifton Labs buffer amp.  I set the gain on that buffer to either 3 or 
> 6 dB when I built it and that's proven to be a good level.  I have the 
> newer LP-Pan with the preamp, but I run with it off as the additional 
> gain just isn't needed.  If I had built the buffer with zero dB gain, 
> the preamp may have been useful.
>
> 73, Floyd - K8AC
>
>
> On 2/13/2014 12:00 PM, tentec-request at contesting.com wrote:
>> From: Barry N1EU<barry.n1eu at gmail.com>
>> To: Discussion of Ten-Tec Equipment<tentec at contesting.com>,    Orion565
>>     <orion565 at yahoogroups.com>
>> Subject: [TenTec] Anyone using LP-PAN with Orion/RX366?
>> Message-ID:
>>     <CAFmfzDtxjo_uZrDSGxKe35sULpjn4GZBtMzB4UaK7jZHQpaNZA at mail.gmail.com>
>> Content-Type: text/plain; charset=UTF-8
>>
>> Is anyone out there successfully using LP-PAN pan adapter with the
>> 9MHz output of the RX366 subreceiver?  Are you using a buffer amp on
>> the if output or using the optional add-on LP-PAN preamp (as suggested
>> by John Henry)?  Any other comments/tips appreciated.
>>
>> Thanks & 73,
>> Barry N1EU
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> .
>