[TowerTalk] rotor plate bolt hole patterns

[ValErwin@aol.com]

Guys:

I also have a US Tower but different model.  I also found that the T2X would 
not fit -- if you tried to pass it through the zig-zags.  But, I found that I 
could use the T2X by  shoving the T2X  in from the very bottom and on up the 
inside of  the tower, when it was tilted  over.  Then, when you get to the 
bottom of the rotor shelf, remove the shelf, and continue on past with the 
T2X. Then, replace the shelf and  drop the T2X down onto the shelf.  When my 
T2X rotates, the "bolt ears" of the T2X pass within 0.25 inches of the 
zig-zags.

GL

Val Erwin
W5PUT

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm