[TowerTalk] How is the best way to bend rebar
Bill Turner
dezrat at copper.net
Sun Aug 27 00:08:24 EDT 2006
ORIGINAL MESSAGE:
On Sun, 27 Aug 2006 04:01:23 +0000, "Donald Chester"
<k4kyv at hotmail.com> wrote:
>Cutting it with a hacksaw isn't difficult. Just saw a small nick in one
>side, less than 1/4 way through the bar, bend it away from the cut, and it
>will break into two pieces cleanly.
------------ REPLY FOLLOWS ------------
A cutoff blade in a circular saw works good too. Almost effortless, in
fact.
--
Bill, W6WRT
More information about the TowerTalk
mailing list