[TowerTalk] Refurbishing Rohn Bearings

[john at kk9a.com]

According to K1VR, it was first posted on towertalk and then printed in the 
NCJ .
 http://lists.contesting.com/archives//html/Towertalk/2007-01/msg00421.html


----- Original Message ----- 
From: "jeremy-ca" <km1h at jeremy.mv.com>
To: <john at kk9a.com>; <TOWERTALK at contesting.com>
Cc: <jokamitsu at yahoo.com>
Sent: Sunday, August 26, 2007 10:00 PM
Subject: Re: [TowerTalk] Refurbishing Rohn Bearings


Excellent information and originally posted in the YCCC Scuttlebut where the
dual bearing suggestion first surfaced.

Carl
KM1H


----- Original Message ----- 
From: <john at kk9a.com>
To: <TOWERTALK at contesting.com>
Cc: <jokamitsu at yahoo.com>
Sent: Sunday, August 26, 2007 7:57 PM
Subject: [TowerTalk] Refurbishing Rohn Bearings


>I just did a quick archive search and found this:
> http://lists.contesting.com/_towertalk/1998-12/msg00118.html
>
>
> [TowerTalk] Refurbishing Rohn Bearings
>      from [Jeffrey Okamitsu] [Permanent Link][Original]
>
>      To:  towertalk at contesting.com
>      Subject:  [TowerTalk] Refurbishing Rohn Bearings
>      From:  Jeffrey Okamitsu <jokamitsu at yahoo.com>
>      Date:  Sun, 26 Aug 2007 14:59:25 -0700 (PDT)
>      List-post:  <mailto:towertalk at contesting.com>
>
> Someone posted a very nice guide on how to refurbish a
> Rohn Thrust Bearing.
>
> I thought I saved it, but apparently not.
>
> Can someone please re-post?
>
> FYI. The post I'm looking for recommends the use of a
> baking pan as a work area to keep from having the ball
> bearings get all over the place.
>
> Thanks
>
> 73, Jeff
>
> W3KL
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>