[TowerTalk] Stripping LMR-600

[Roger (K8RI)]

Tommy Alderman wrote:
>  
>
> What is the recommended tool for stripping LMR-600 for a type-N connector?
> Do most of you use just a sharp blade and careful measurements or do you
> recommend the purchase of a stripping tool? If you use a stripping tool, can
> you give me a model number and a source please? I'm going to be doing a
> limited quantity of less than ten connectors.
>
>   
I purchased one through Davis (Orion Wire). Works just fine.

73

Roger (K8RI)
>  
>
> Thanks for any information.
>
>  
>
> Tom - W4BQF
>
>  
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>