[TowerTalk] Stripping LMR-600

[Tommy Alderman]

Thanks Roger. Can you also cut the braid shield and the dielectric with that
stripping tool?

Thanks again.

73,


Tom - W4BQF



-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Roger (K8RI)
Sent: Wednesday, April 21, 2010 8:38 AM
To: Tower and HF antenna construction topics.
Subject: Re: [TowerTalk] Stripping LMR-600



Tommy Alderman wrote:
>  
>
> What is the recommended tool for stripping LMR-600 for a type-N connector?
> Do most of you use just a sharp blade and careful measurements or do you
> recommend the purchase of a stripping tool? If you use a stripping tool,
can
> you give me a model number and a source please? I'm going to be doing a
> limited quantity of less than ten connectors.
>
>   
I purchased one through Davis (Orion Wire). Works just fine.

73

Roger (K8RI)
>  
>
> Thanks for any information.
>
>  
>
> Tom - W4BQF
>
>  
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk