[TowerTalk] Rohn 45AG4 guy tabs?

[john at kk9a.com]

I used the top plate holes to guy the P40A Rohn 55G tower and it worked out 
well.  The top plate hole was too small for my guy cable thimble so a 
shackle was needed.



To:Tower Talk <TowerTalk at contesting.com>
Subject:[TowerTalk] Rohn 45AG4 guy tabs?
From:Jay Kesterson <k0gu at verinet.com>
Date:Fri, 16 Aug 2013 14:42:57 -0600
List-post:<towertalk at contesting.com">mailto:towertalk at contesting.com>

I see at least one Rohn 45 seller's web site that calls the tabs on the 
45AG4 top plate guy tabs. However I don't see any reference to that in the 
Rohn documentation. Except for dimensions Rohn doesn't really say a lot 
about the 45AG4. But Rohn always shows the guys attached a few feet below 
the tower. So are they guy tabs? I was planning on using them on a tower 
with a tall mast (the mast is another subject that will get a post here in a 
bit). Guy the tower at the top plate and then not far under the rotator. 
Anyone have the scoop on this.
73,  Jay  K0GU