[TowerTalk] LMR600 male DIN
Bob K6UJ
k6uj at pacbell.net
Thu Sep 8 15:11:16 EDT 2016
Paul,
Good question. I was comparing both of these feedlines also.
I haven't used either one so I rely on the comments here on our
reflector.
Here's a quote from Roger, K8RI
"I found 1/2" Heliax too fragile for kinking, or being stepped on. I
gave away two 100' runs with connectors. and went to LMR600"
Bob
K6UJ
On 9/8/16 10:57 AM, Paul Christensen wrote:
>> "## RFS 1/2 inch heliax is $1.48 ft from davis RF."
> N4CC and I are gearing up to move our remote internet station about a
> half-mile down the edge of the Okefenokee Swamp. The move is a big hassle
> but topography is even better than the current site.
>
> Above ground, we're going to re-use TerraWave TWS-600 cabling since it's
> only about one year old. TWS is a generic equivalent to Times LMR-600.
> However, for underground cabling, I'm looking at direct burial of either
> gel-flooded TWS-600 or RFS 1/2-inch Cellflex hardline. Pricing is roughly a
> wash when considering cable and connector cost -- and I assume the same for
> shipping.
>
> Preference to one installation over the other? The RFS line has a slightly
> better loss spec, but not by much.
>
> Paul, W9AC
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
More information about the TowerTalk
mailing list