[Trlog] Keyboard command to switch vfos

[Ronald Rossi]

You need a semi-colon at the end of each command for the Kenwoods. It is 
likely the same for Elecraft.

FR0; = VFO A Rx
FR1; = VFO B Rx
FT0; = VFO A Tx
FT1; = VFO B Tx

Ken Beals wrote:

> Bob:
> 
> Go to the Elecraft site and download the "KIO2
> Programmer's Manual".  It has all the codes for the
> K2.  
> 
> Looks like an FR0 (that's a zero) will set VFO A
> receive, FR1 sets VFO B receive.  This command also
> sets the split mode on/off automatically.  That should
> be all you need.  
> 
> Otherwise you can always use the SW commands and get
> any combination of button presses you need.
> 
> Ken
> 
> --- Bob Tellefsen <n6wg at comcast.net> wrote:
> 
> 
>>I'm working on programming a couple of buttons to
>>allow
>>keyboard switching from vfo A to B and back again.
>>George Fremin pointed me to section 5.3 in the
>>manual, which
>>shows how, sort of, but I need to know what codes a
>>Kenwood
>>would want to see to do this.  I'm actually using a
>>K2, but it is
>>supposed to accept the Kenwood codes.
>>
>>Can anyone help with this?
>>Thanks and 73
>>Bob N6WG
>>_______________________________________________
>>Trlog mailing list
>>Trlog at contesting.com
>>http://lists.contesting.com/mailman/listinfo/trlog
>>
> 
> 
> _______________________________________________
> Trlog mailing list
> Trlog at contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
> 
> 

-- 
73 es God Bless de KK1L...ron (kk1l at arrl.net) <><
QTH: Jericho, Vermont
My page: http://www.qsl.net/kk1l